Title

Immersion cooling of a simulated electronic chip protruding into a flow channel

Abstract

Nucleate boiling and critical heat flux from the top and side surfaces of a simulated electronic chip protruding into a rectangular channel has been studied. To ascertain the contributions of heat transfer from the sides and top of the simulated electronic chip, boiling from the sides was virtually eliminated by the use of a thin (0.025 mm) foil heater on top of a block of insulating material. It was found that single-phase heat transfer and critical heat flux are markedly greater for a surface protrusion height of 0.71 mm as compared to a flush surface. This increase was seen for flow velocities greater than 1 m/s and a subcooling of 20°C. The results are compared to that for a copper block heated from below under similar fluid and geometry constraints. These comparisons show that the vapor emanating from the upstream side of the copper block plays an important role in either decreasing or increasing the critical heat flux. Additional results were obtained for the copper block where heat transfer from the upstream side was obstructed. These results indicate that under some conditions of subcooling and flow rate an optimal amount of upstream side vapor production exists.

Publication Date

1-1-1998

Publication Title

Journal of Thermophysics and Heat Transfer

Volume

12

Issue

3

Number of Pages

398-405

Document Type

Article

Personal Identifier

scopus

DOI Link

https://doi.org/10.2514/2.6351

Socpus ID

0032116503 (Scopus)

Source API URL

https://api.elsevier.com/content/abstract/scopus_id/0032116503

This document is currently not available here.

Share

COinS